UE TX200H, Installation And Maintenance Instructions Manual

Page: 5 / 6

IMTX200H-03
www.ueonline.com
Part IV - TX200H HART CoMMANDS
Command Number Universal Commands, Command Function
0 Read Unique Identifier Distributor, model, device id, tag, date, ID code, device type code (E18D) sw rev, device id,
1 Read Primary Variable
2 Read Loop Current and Percentage of Range
3 Read Current and up to Four Dynamic Variables
6 Write Polling Address
7 Read Loop Configuration
8 Read Dynamic Variable Families
9 Read up to Four Device Variables with Status
11 Read Unique Identifier Associated with Tag
12 Read Message
13 Read Tag, Descriptor, Date
14 Read Primary Variable Transducer Information
15 Read Device Information
16 Read Final Assembly Number
17 Write Message
18 Write Tag, Descriptor, Date
19 Write Final Assembly Number
20 Read Long Tag
21 Read Unique Identifier Associated with Long Tag
22 Write Long Tag
38 Reset Configuration Changed Flag
48 Read Additional Device Status
Command Number Common-Practice Commands, Command Function
33 Read Device Variables
34 Write Primary Variable Damping Value
35 Write Primary Variable Range Values
36 Set Primary Variable Upper Range Value
37 Set Primary Variable Lower Range Value
40 Enter/Exit Fixed Current Mode
42 Perform Master Reset
43 Set Primary Variable (Trim) Zero
44 Write Primary Variable Units
45 Trim Loop Current Zero
46 Trim Loop Current Gain
47 Write Primary Variable Transfer Function
54 Read Device Variable Information
59 Write Number of Responses Preambles
71 Lock Device (Allows a Master to temporarily or permanently lock the device)
76 Read lock status