IMP100-06
IMP100-06
RECOMMENDED PRACTICES AND WARNINGS
United Electric Controls Company recommends careful consideration of the following factors when
specifying and installing UE pressure and temperature units. Before installing a unit, the Installation and
Maintenance instructions provided with unit must be read and understood.
• To avoid damaging unit, proof pressure and maximum temperature limits stated in literature and on
nameplates must never be exceeded, even by surges in the system. Operation of the unit up to
maximum temperature is acceptable on a limited basis (i.e., start-up, testing) but continuous operation
must be restricted to the designated adjustable range. Excessive cycling at maximum temperature limits
could reduce sensor life.
• A back-up unit is necessary for applications where damage to a primary unit could endanger life,
limb or property. A high or low limit switch is necessary for applications where a dangerous runaway
condition could result.
• The adjustable range must be selected so that incorrect, inadvertent or malicious setting at any
range point cannot result in an unsafe system condition.
• Install unit where shock, vibration and ambient temperature fluctuations will not damage unit or affect
operation. Orient unit so that moisture does not enter the enclosure via the electrical connection.
When appropriate, this entry point should be sealed to prevent moisture entry.
• Unit must not be altered or modified after shipment. Consult UE if modification is necessary.
• Monitor operation to observe warning signs of possible damage to unit, such as drift in set point or
faulty display. Check unit immediately.
• Preventative maintenance and periodic testing is necessary for critical applications where damage
could endanger property or personnel.
• For all applications, a factory set unit should be tested before use.
• Electrical ratings stated in literature and on nameplate must not be exceeded. Overload on a switch
can cause damage, even on the first cycle. Wire unit according to local and national electrical codes,
using wire size recommended in installation sheet.
• Do not mount unit in ambient temp. exceeding published limits.
LIMITED WARRANTY
Seller warrants that the product hereby purchased is, upon delivery, free from defects in material and
workmanship and that any such product which is found to be defective in such workmanship or material
will be repaired or replaced by Seller (Ex-works, Factory, Watertown, Massachusetts. INCOTERMS); pro-
vided, however, that this warranty applies only to equipment found to be so defective within a period of
24 months from the date of manufacture by the Seller. Seller shall not be obligated under this warranty for
alleged defects which examination discloses are due to tampering, misuse, neglect, improper storage, and
in any case where products are disassembled by anyone other than authorized Seller’s representatives.
EXCEPT FOR THE LIMITED WARRANTY OF REPAIR AND REPLACEMENT STATED ABOVE, SELLER DISCLAIMS
ALL WARRANTIES WHATSOEVER WITH RESPECT TO THE PRODUCT, INCLUDING ALL IMPLIED WARRANTIES OF
MERCHANTABILITY OR FITNESS FOR ANY PARTICULAR PURPOSE.
LIMITATION OF SELLER’S LIABILITY
Seller’s liability to Buyer for any loss or claim, including liability incurred in connection with (i) breach of
any warranty whatsoever, expressed or implied, (ii) a breach of contract, (iii) a negligent act or acts (or
negligent failure to act) committed by Seller, or (iv) an act for which strict liability will be inputted to seller,
is limited to the “limited warranty” of repair and/or replacement as so stated in our warranty of product.
In no event shall the Seller be liable for any special, indirect, consequential or other damages of a like gen-
eral nature, including, without limitation, loss of profits or production, or loss or expenses of any nature
incurred by the buyer or any third party.
UE specifications subject to change without notice.
FGS100005/04
Model 540-543
Models 544-548
Models 560-564
Models 565-567
Dimensions
U N I T E D E L E C T R I C
C O N T R O L S
180 Dexter Ave. P.O. Box 9143, Watertown, MA 02472-9143 USA
617 926-1000 Fax 617 926-2568
www.ueonline.com