6
USERS INSTRUCTIONS
GETTING STARTED
On/Off Button: Press the On/Off button to turn the instrument on. To turn off press and
hold the button again.
Sensitivity/Spin and Click dial: Use this dial to store data, move around the various screens
and to setup the instrument (See Section B-1: Moving around the screens using the
Sensitivity/Spin & Click dial).
The SD card slot: Lift the cover and insert the SD card. The card must be inserted to store
data and to review baseline data.
The charging jack: Location to insert the recharger plug. A green light will blink as the unit
is charging a solid green will indicate a full charge.
BNC Connect: Be sure the magnetic mount transducer is attached via the BNC connector
before any lubricating is performed.
Before operating, be sure the magnetic transducer is attached to the docking station and
the docking station is mounted on the end of grease gun tube as shown above.
DISPLAY PANEL SCREENS AND FUNCTIONS
To move around a screen or to enter and use a feature of the “Function Bar” (described
below) there are two ways to use the Sensitivity/Spin and Click dial.
Lightly click to move the blinking indicator/cursor to a feature on the display screen. For
example, to adjust the sensitivity, click the Sensitivity dial until the S= blinks. Spin the
Sensitivity dial clockwise (UP) or counterclockwise (DOWN) to adjust the sensitivity.
The second method is to push and firmly hold the Sensitivity/Spin & Click dial. This is used
to store a reading or enter any of the Function Bar features.
