19
TO CHARGE THE UP3000
The recharger has a 5-pin mini USB plug that connects to the 5-pin mini USB jack on the Ultraprobe.
Plug the recharger into an electric outlet and then place the 5-pin mini USB plug into the 5-pin mini
USB jack on Ultraprobe 3000.
The LED on the charger will be flashing when charging and then turn solid green when fully charged.
Charging will take about one hour.
Remove the charger from the electric outlet when fully charged
WARNING:
Use the supplied UE Systems recharger only. Use of unauthorized rechargers
will void the warranty and may damage the battery and or instrument.
WARBLE TONE GENERATOR (UE WTG 1)
Turn Tone Generator on by selecting either "LOW" for a low amplitude signal (usually
recommended for small containers) or "HIGH" for high amplitude. In high, the Warble Tone
Generator will cover up to 4,000 cubic feet (121.9 cu. meters) of unobstructed space.
When the Tone Generator is on, a red light (located below the recharge jack in the front)
flickers.
To test the condition of the Warble Tone Generator battery, set to the LOW INTENSITY
position and listen to the sound through the Ultraprobe at 40 kHz. A continuous warbling
sound should be heard. If a "beeping" is heard instead, then a full recharge of the Warble
Tone Generator is indicated.
TO CHARGE THE WARBLE TONE GENERATOR
Plug the Tone Generator plug (yellow) on the Warble Tone Generator and then plug the
recharger into an electric outlet.
Make sure that the LED on the charger for the tone generator is flashing when recharging.
The LED turns solid when the battery is charged.
