17
METHOD OF AIRBORNE DETECTION
The method of air borne detection is to go from the "gross to fine". Start off at a high sensitivity level
and if there is too much ultrasound in the area, reduce the sensitivity, following the sound to the
loudest point. If necessary, place the RUBBER FOCUSING PROBE (described below) over the scanning
module and proceed to follow the test sound to its loudest point constantly reducing the sensitivity
while following the bar graph indicator on the display.
HEADPHONES
To use, firmly plug the headphone jack into the “Phones” receptacle on the pistol
housing and place the
headphones over your ears.
RUBBER FOCUSING PROBE
The Rubber Focusing probe fills two functions: it deflects stray ultrasounds and enhances the reception
of weak airborne signals. To use, simply slip it over the front of the scanning module or the contact
module.
NOTE:
To prevent damage to the module plug, always remove the module BEFORE attaching
and/or removing the Rubber focusing Probe.
USERS INSTRUCTIONS
SCANNING MODULE
Plug in to front end.
Align the plug located at the rear of the module with the receptacle in the front end of the
Pistol Housing and plug in.
Start to scan the test area.
