Smart Bluetooth Robot Car Kit for Arduino
12
www.uctronics.com
With the car platform, adding micro-controller (such as Arduino) and sensor modules, then
program it, a robot car comes up.
All the module interfaces have been modified with XH2.54 ports as to make it much easier
and convenient to assemble the car.
2.5.1 Specification
With battery container
Gear Motor reduction radio: 48:1
Apply in distance measurement, velocity
2.6 HC-05 Bluetooth Serial transmission Wireless Module
This module is mainly used in the field of wireless transmission of data over short distances. It
can be easily connected to PC Bluetooth device and also can exchange data between two
modules. Direct serial cable replacement avoids the cumbersome cable connections.
2.6.1 Specification
Interface: VCC, GND, TXD, RXD, KEY, STATE (Note: The Pin for STATE, low output when
unconnected, high out when after the connection)
LED indicates the connection state of the Bluetooth, quick flash indicates no connection,
slow flash indicates the module enter into the AT mode, double flash indicates the
successfully connection of the Bluetooth and the open port
The bottom plate is set to an anti-reverse diode with 3.3V LDO, the input voltage
3.6-6V, unpaired current is 30mA, 10mA after pairing, the input voltage is prohibited more
than 7V
Summary of Contents for Smart Bluetooth Robot Car
