- 42 -
calibration to reduce manufacturing and degradation errors.
Do not compare your readings obtained from sources such as
the internet, radio, television or newspapers. They are in a
different location and typically update once per hour.
The purpose of your weather station is to measure conditions
of your surroundings, which vary significantly from location to
location.
9.1 Calibration of Temperature Mode
In normal mode, press and hold the
SET
and
C
keys at the same time for five seconds to enter the temp
calibration mode. The indoor temperature will begin flashing.
Press the
C
key or
MAX/MIN/-
key to increase or
decrease the temperature reading (in increments of 0.1). Press
and hold the
C
key or
MAX/MIN/-
key for three
seconds to increase or decrease rapidly.
Press the
ALARM
key to reset current value.
Press the
SET
key switch to outdoor temp calibration mode.
To exit the temperature calibration mode at any time, press the
SNOOZE/LIGHT
or
SET
button . If no operation is performed,
the calibration mode will timeout in 30 seconds.
Summary of Contents for FT0365
