2
UCoustic 9210 manual V1
The way a cabinet should sound
UCoustic
™
9210 Floor Standing Cabinet
Thank you and congratulations for purchasing the UCoustic 9210 freestanding
acoustic cabinet. Please follow these simple recommendations in order to get the
best from your new enclosure.
Tools Required:
2 point Pozi Drive Screwdriver
10mm AF Spanner to suit M6 Nut
Cabinet Siting:
Great care should be taken when siting both
the passive and active cabinets..
1. Avoid siting cabinets next to room
heating e.g. radiators
2. Where possible avoid siting near
windows (to avoid solar gain)
3. Where possible site cabinet in an air
conditioned room or in a well vented
space
4. Check floor loading capacity. Due to
the weight combination of both the
cabinet and equipment housed, it
maybe necessary to use a floor load
spreader plate Pt No. RA0-008
2
-AA
Removal of Cladding
NB.
We recommend that this is performed as a two
man operation
To remove
U
front passive wardrobe doors
U
, turn
cam lock with key supplied, lift swing handle
and turn clockwise, open doors taking care to
open without disturbing soundproof seals.
When doors are open lift individually each side
just high enough to clear hinge pins and safely
stand the door against a solid wall.
To remove
U
rear doors
U
, disconnect mains supply,
turn cam lock with key supplied, lift swing
handle and turn clockwise, hold left hand door
in position whilst opening right hand door taking
care to open without disturbing the sound proof
seals.
Each door has a cooling fan connected to a fan
speed controller sited behind the side infill’s.
Ensure fan speed controller is not connected to
its supply BEFORE proceeding with rear door
removal and note the polarization of the
connector for later reconnection. Disconnect
each fan at the rear of the door by squeezing
the retaining clips on the white connectors and
pulling them apart. When doors are open and
main door is away from frame, lift off each door
and safely stand it against a solid wall.
To re-hang the
U
rear doors
U
, reverse procedure
above remembering to refit the fan connectors
after reassembly of doors to cabinet and then
reconnect mains supply
To remove the side panels simply turn cam
locks with keys supplied and lift panel and place
against solid wall, again the panels are very
heavy so we recommend a minimum of two
people carry out this task.
Handling
Personal care
To achieve the level of acoustic performance
and industrial needs of a high quality 19”
enclosure the composition of cabinet parts
means that the 9210 UCoustic cabinets are
very
heavy
when moving the cabinet we recommend
a minimum of two people carry out this task.
The individual doors and side panels are also
very heavy and need to be handled with care,
again we recommend that a minimum of two
people remove and assemble the cladding onto
the cabinet.
