AeroCut X / XPro SERVICE MANUAL
60
(d)
Barcode with USERDATA
Barcode is used to call up USERDATA from memory.
Therefore, in case USERDATA is not pre-programmed in memory, it is
impossible to call up data and operate.
Note that if there is a difference between USERDATA and the actual
contents of printed materials, printed materials will not be finished correctly.
Using barcode without Plug-in Software
①
Create a job program by MANUSET or FLEXMODE, and memorize it as
USERDATA.
(Refer to Operation Manual 3.5 SAVE / READ)
②
Refer to USERDATA No. (3 digits) and create 7 digits Barcode.
(Ex: If USERDATA No. is 10, machine is Prime and Machine number is 0,
Barcode should be ACP0010.)
③
According to the section 1. Detail of Barcode, put the barcode on an artwork
and print.
④
Set the prints and select Barcode Job Check or Barcode Job Change on
the screen. Then press the START.
Using barcode with Plug-in Software
①
After starting Illustrator or InDesign, create job program by Plug-in and save
it into AeroCut.
(Refer to Operation Manual of Plug-in (2)-(d)-
③
)
②
Tick Barcode and press OK. Then barcode is generated and put on the
artboard automatically.
③
Print the artwork.
④
Set the prints and select Barcode Job Check or Barcode Job Change on
the screen. Then press the START.
Summary of Contents for AeroCut X
