AeroCut XPro OPERATION MANUAL
52
24
Crease trailing edge error
Correct the crease trailing edge to exceed the
value specified below.
25
FLEX MODE input error 2
Slitter units positioning error.
Slitter position is out of valid range.
Check paper size and input data.
28
Crease error
The creaser has moved and staying at upper
position.
Move the creaser to bottom dead center.
29
Cutting measurement error
Correct the cutting measurement to fit in the
value range below.
The maximum value is subject to change
depending on the entered paper size.
36
Communication error
Communication with the touch panel is not
possible.
Turn off the power, and turn it on again after 5
seconds or longer.
37
Crease leading edge error
Correct the crease leading edge to exceed the
value specified below.
