Ubiquiti airFiber 11FX, User Manual, Page: 19 / 58

13
Chapter 2: Installation airFiber AF-11FX User Guide
Ubiquiti Networks, Inc.
5. Master Aim the Master at the Slave to achieve the
strongest signal level on the Slave.
6. Repeat steps 4 and 5 until you achieve an optimal link,
with all four Signal LEDs solidly lit. This ensures the best
possible data rate between the airFiber X radios.
7. Lock the alignment on both airFiber X antennas by
tightening all the nuts and bolts.
8. Observe the Signal LEDs of each airFiber X radio
to ensure that the values remain constant while
tightening the nuts and bolts. If any LED value changes
during the locking process, loosen the nuts and bolts,
finalize the alignment of each airFiber X antenna again,
and retighten the nuts and bolts.
Refer to the following chapters of this User Guide for
details on the airFiber Configuration Interface:
• “Dashboard” on page 17
• “Wireless Tab” on page 21
•
“Network Tab” on page 25
• “Services Tab” on page 29
• “System Tab” on page 33
• “Tools” on page 37
Installer Compliance Responsibility
Devices must be professionally installed and it is the
professional installer’s responsibility to make sure the
device is operated within local country regulatory
requirements.
The Output Power, Antenna Gain, Cable Loss * , TX Frequency,
and RX Frequency fields are provided to the professional
installer to assist in meeting regulatory requirements.
* Cable Loss includes loss due to the Duplexer(s).