25
Appendix D: Compliance Information
airCam
™
Mini User Guide
Ubiquiti Networks, Inc.
Appendix D: Compliance
Information
Installer Compliance Responsibility
Devices must be professionally installed and it is the
professional installer’s responsibility to make sure the
device is operated within local country regulatory
requirements.
FCC
Changes or modifications not expressly approved by the
party responsible for compliance could void the user’s
authority to operate the equipment.
NOTE: This equipment has been tested and found
to comply with the limits for a Class A digital device,
pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against
harmful interference when the equipment is operated in
a commercial environment. This equipment generates,
uses, and can radiate radio frequency energy and, if not
installed and used in accordance with the instruction
manual, may cause harmful interference to radio
communications. Operations of this equipment in a
residential area is likely to cause harmful interference
in which case the user will be required to correct the
interference at his own expense.
RF Exposure Warning
The transceiver described here emits radio frequency
energy. Although the power level is low, the concentrated
energy from a directional antenna may pose a health
hazard. Do not allow people to come closer than 20 cm to
the antenna when the transmitter is operating.
Additional information on RF exposure is available on the
Internet at
www.fcc.gov/oet/info/documents/bulletins
L’émetteur-récepteur décrit ici émet de l’énergie de
fréquence radio. Bien que le niveau de puissance est faible,
l’énergie concentrée à partir d’une antenne directionnelle
peut présenter un danger pour la santé. Ne pas permettre
aux gens de se rapprocher de 20 cm à l’antenne lorsque
l’émetteur est en marche.
Des renseignements supplémentaires sur l’exposition aux
RF est disponible sur Internet à
www.fcc.gov/oet/info/
documents/bulletins
Industry Canada
This Class A digital apparatus complies with Canadian
ICES-003.Operation is subject to the following two
conditions:
1. This device may not cause interference, and
2. This device must accept any interference, including
interference that may cause undesired operation of the
device.
To reduce potential radio interference to other users, the
antenna type and its gain should be so chosen that the
equivalent isotropically radiated power (e.i.r.p.) is not more
than that permitted for successful communication.
Cet appareil numérique de la classe A est confrome à la
norme NMB-003 Canada. Son fonctionnement est soumis
aux deux conditions suivantes:
1. Cet appareil ne peut pas provoquer d’interférences et
2. Cet appareil doit accepter toute interférence, y compris
les interférences susceptibles de provoquer un
fonctionnement du dispositif.
Pour réduire le risque d’interférence aux autres
utilisateurs, l’antenne type et son gain doivent être
choisies de façon que l’équivalent puissance isotrope
rayonnée équivalente (pire) n’est pas plus que cela
autorisé pour une communication réussie.
CE Marking
CE marking on this product represents the product is in
compliance with all directives that are applicable to it.
Alert sign! Follows CE marking
Alert sign must be indicated if a restriction on use applied
to the product and it must follow the CE marking.
NB-Identification number (if there is any)
Notified body number is indicated if it is involved in the
conformity assessment procedure.
Please check the CE mark on the product label to find out
which notified body was involved during assessment.
