Ubee Interactive — www.ubeeinteractive.com
6
Ubee DVW328 – Safety and Installation Product Insert v1.0
Additional Information
1. RESET Button (back of device): This button
resets the device to factory defaults. Using a
pointed object, insert it into the button opening,
and hold for more than 10 seconds. The
device will reset and reboot.
Note
: Not all
parameters are reset to factory defaults. Refer
to the User Guide for more information.
2. WPS button (top of device): The WPS button
is used for the Wi-Fi Protected Setup (WPS)
method to connect a Wi-Fi device to the
DEVICE. Refer to the User Manual for more
information.
3. USB Connector (back of device): USB devices
can be connected here, such as flash drives,
external HDDS, printers, etc.
LEDs and Other Device Indicators
See the following diagram and descriptions of the
device’s LED behavior, and the behavior of the
back-panel Ethernet indicators.
LED Indicators (Color = Blue When On)
:
POWER
—If On, indicates that the device has
successfully completed internal power-on tests.
LED flashes if power-on fails. Note that the LED
flashes briefly immediately after powering the
device.
DS/US
—When the device initializes, the LED
flashes. When the device locks on to channels
and registers OK, the LED is On. When the
device performs a firmware upgrade, the LED
flashes.
ONLINE
—When the device is obtaining an IP
address and configuration file, the LED flashes.
When device obtains these items, the LED is On.
