UBCO 2x2 2018, User Manual

Page: 27 / 31

M5 X 12.5 mm
WASHER
M6 X 12.5 mm
WASHER
M5 NYLOC NUT M6 NYLOC NUT
M5 x 40mm
COUNTERSUNK
ANTISPIN
WASHER
RIGHT TORQUE ARM
M5 x 16mm
48 49
Removing Front Mud Guard
Removing the front mud guard can be completed
in a few easy steps. It is easier to remove the mud
guard if the front wheel is removed.
a. Using a 3mm Allen key, remove the two side
bolts connecting the wire mud guard stay to the
fork near the brake calliper.
b. Using a 3mm Allen key and 8mm spanner,
remove the two bolts that hold the mud guard
to the fork arch.
c. Remove the mud guard.
Replacing Brake Pads
The 2×2 includes front and rear hydraulic disk
brakes, operated by levers on the handlebars.
Ensuring your brake pads are in good condition
is critical to your safety. Check the brake pads
regularly, especially when a lot of heavy braking
has occurred.
Replacement brake pads are Tektro D40.11 and are
available from Ubco Ltd.
Brake rotors get hot during braking. Allow
sufficient time for brakes to cool before
touching or doing any maintenance.
To replace the brake pads:
a. Unscrew the pin on the top of the calliper body
with a number 3 Allen key, remove the end clip
and pull the pin out.
b. Remove the brake pads from the top of the
calliper and discard. Guide new brake pads in,
from the top of the calliper, until the holes line
up. Do not touch the pad surface with your skin.
c. Re-install the fastening pin and tighten with the
Allen key. Replace the end clip.
a.
b.
c.