UBCO 2x2 2018, User Manual

Page: 26 / 31

REAR TORQUE ARM M14 SERATED
FLANGE NUT
AXLE BUSH SPACER INSERT
LEFT TORQUE ARMRIGHT TORQUE ARM
LEFT TORQUE ARMRIGHT TORQUE ARM
SPACER INSERT
M8 x 25mm
COUNTERSUNK
REAR TORQUE ARM REAR TORQUE ARM M14 SERATED
FLANGE NUT
M6 X 16 mm
WASHER
M8 NYLOC NUT M8 FLANGE NUT
46 47
Wheels
The front and rear wheels are identical except for
the inserts installed on the axles. This means either
wheel can be installed at the front or rear if the
correct inserts and torque arms are used.
Removing the Front Wheel:
a. Unscrew the motor cable locking sleeves and
detach the two motor cable ends.
b. With a No. 21 spanner, loosen the two serated
flange nuts. (
TOOL TIP: It is easiest to remove
the nuts from the axle).
c. Remove the left and right torque arms from the
recesses in the fork, the wheel is now free to be
removed from the fork.
d. When putting the wheel back on ensure
that the nuts are tightened to 80 Nm with
a torque wrench.
Removing the Rear Wheel:
a. Unscrew the motor cable locking sleeves and
detach the two motor cable ends.
b. Using a 6mm Allen Key unscrew and remove
the two M8 countersunk cap screws on the
torque arms.
c. With a No. 21 spanner, loosen the two serated
flange nuts. ( TOOL TIP: it is easiest to remove
the nuts from the axle).
d. Remove the left and right torque arms from the
recesses in the swing arm. The wheel is now
free to be removed.
e. When putting the wheel back on ensure
that the nuts are tightened to 80 Nm with
a torque wrench.
Swapping Front and Rear Wheels
The front and rear wheels each have spacer inserts
which are installed on the axles. These inserts are
specific for installation in the front fork and rear
swing arm. If you wish to swap the wheels around
for whatever reason, be sure to swap these inserts
and torque arms before installing into the bike.
Directional indicators, reflectors, rear light, number plate holder and mirrors on the road version only.