9
When beer is dispensing through the faucet, condensation may form on
the outer surface of the faucet.
This is a normal condition and cannot be avoided. This is caused by
temperature differentials between cold beer flowing across the warmer
ambient surfaces of the inner faucet.
Always make sure the faucet handle is pushed fully back (closed) to
prevent excess dripping.
CLEANING BEER
6.5 Technical service
Technical service of the keg cooler has to be conducted by trained
licensed technicians who are aware of the local electrical safety rules.
No special equipment is required for daily service.
Daily service includes the following: conducting visual inspection for
physical damages of the keg cooler and the power cord, checking the
beer and CO2 hoses for leaks.
WARNING: Never turn the keg cooler over. It might permanently damage
the compressor.
WARNING: Pressure of CO2 must not be above 51 psi/lbs.
7. Emergency situations
In case of a short circuit, immediately cut the power and turn off the
CO2 manifold.
8.
Spare Parts
Ordering spare parts
When ordering a spare part please refer to the spare part drawing and
look up the specific spare part number.
Please state carefully the spare part number, the specification and
quantity wanted before you send your order.
If, though, a certain part is not specified in this section, do not hesitate
to contact us for further information.