6
Safety instructions
WARNING: Instructions pertaining to the risk of fire, electric shock, or
injury to persons.
GROUNDING INSTRUCTIONS
For your personal safety, this appliance must be grounded. In the event of a
malfunction or breakdown, grounding will reduce the risk of electric shock by
providing a path of least resistance for electric current.
This appliance is equipped with a power cord having equipment grounding
conductor and grounding plug. The plug must be plugged into an appropriate
wall outlet that is installed and grounded in accordance with all existing local
codes and ordinances. Consult a qualified electrician or serviceman if the
grounding instructions are not clearly understood or if doubt exists as to
whether your electrical wall outlets are properly grounded.
WARNING
The manufacturer is not responsible for possible damage caused by
improper and unsafe usage of the keg cooler.
Set up instructions.
Unpack the keg cooler and place it in the selected location.
LOCATION
• Selecting the proper location will ensure best performance levels of your
appliance. Choose a location away from heat emitting sources.
• This appliance is designed for "indoor" and "outdoor" use.
• This appliance should not be built-in (recessed) unless adequate ventilation
is provided to maintain proper cooling.
1)
Install the dispensing tower onto the top using the fasteners
provided.
Install the faucet facing the door of the keg cooler onto the tower.
2)
Install manifolds onto the CO2 cylinder.
3)
Connect CO2 hose to the manifold and secure hose by using snap
on clamps (use pliers to snap the clamp tight to assure that there are
no leaks).
4)
The length of the CO2 hose should allow reaching the coupler on a
keg inside the keg cooler.
5)
Draw the CO2 hose into the keg cooler through a hole in the back.
6)
Connect the CO2 hose to the coupler and secure hose by using snap
on clamps.
7)
Connect
the
beer
tube to the coupler and secure hose by using snap
on clamps.
8)
Connect the other end of the beer tube to the dispensing tower and
secure hose by using plastic snap on clamps.
9)
Insert the free end of plastic air hose into the dispensing tower.
