UAV-1003599-001
20
Rev A
Gauge
ohm/km
Maximum Length for 0.5ohm
20 AWG
35
14.2m
22 AWG
64
7.8m
1. Prepare the aircraft wiring for connection.
a. Install a shielded 24AWG twisted pair cable from the cockpit to
the tailBeaconX installation location. This cable is used for
interface control (data). Installations requiring suppression input
should install a separate single shielded wire. Installations not
requiring suppression input require only 4 total conductors to
provide power, ground, serial receive, and serial transmit
(control).
b. Install a ground wire from the aircraft airframe or battery
ground. Prepare bonded surfaces for best contact. Resistance
of connection to ground should be less than 0.003 ohms.
(AC43.13-2B chapter 11)
