For questions or concerns, e-mail [email protected], visit www.ussolid.com, or
call (800) 209-4177
VI. Cleaning the Machine
1. Shut off the power and unplug the machine.
2. If pressing chamber is hot, wear cotton, heat-protective gloves
to prevent burns. Alternatively, wait for 60 minutes to let the
pressing chamber cool down completely.
3. According to the graphic below, remove the four nuts from the
pressing chamber with a wrench.
4. Take out the pressing rod.
5. Clean it and then rinse.
6. Clean the pressing chamber with water.
Putting the Machine Back Together
•
Screw the stem casting into the bearing.
•
Attach the external pressing chamber.
•
Screw the four nuts on by hand.
•
Gently tighten them with the wrench.
Note: Never over-tighten the four nuts.
Summary of Contents for USSOILP1
Page 20: ......
