VAC (1) & PUMP (2) SWITCHES:
These switches are powered by cord #1. Switches are on when illuminated.
CARPET/UPHOLSTERY SWITCH (3):
This switch is also powered by cord #1. The carpet setting (down position) is high pressure
(approximately 300 PSI). The upholstery setting (up position) is low pressure (approximately
50 PSI with a K1 or V2 spray tip). NOTE: Switch does not illuminate.
BYPASS SWITCH (4):
Turning on this switch (switch illuminates when on) bypasses the circuit locator.
GREEN CIRCUIT LOCATOR LIGHT (5):
When this light is illuminated, it confirms that the machine is on two separate circuits.
HEAT MODE LIGHT (6):
This light will only illuminate when the heater is heating and will turn off when it reaches
operating temperature. Note: this light will be on most of the time during normal operation.
CAUTION:
THE CIRCUIT BREAKER CAN TRIP IF BOTH CORDS ARE ON THE SAME CIRCUIT AND
THE BYPASS SWITCH IS TURNED ON.
#1
#2
#3
#4
VAC 1
PUMP
CARPET
BYPASS
LOCATOR
#5
UPHOLSTERY
MODE
#6
1
2
3
4
VAC 1
VAC 2
PUMP
BYPASS
LOCA
TOR
MODE
HOLDING TANK LID
SWITCH PLATE
LID (RECOVERY TANK)
VAC INTAKE
LATCH (2)
DRAIN GATE
CASTOR
VENT
PRIMING HOSE IN
POSITION FOR PRIMING
WHEEL
