5
4
Speed
Time
Time
Mode
Reset
Speed-down
Fat testing/Mode
Speedup
Armrest
Control Panel
Upper Stand
Decorative Cover
Lower Stand
Footplate / Base
Resistance Bands
Pedestal Cover
Adjustable Feet
Part Names
Accessories
Installation
2. Grasp the cord attached to the Control Panel and
tuck it into one end of the Upper Stand. Fit the
Control Panel onto that end, making sure that it is
and 2 M5 lock washers to fasten the Control Panel
to the top end of Upper Stand
inserted all the way in. Use the two M5x14 screws
3.
1. Remove all protective wrapping from the unit’s
parts. Unscrew the two bolts on the bottom of the
Control Panel. Install to the Tube seen in Figure 2.
IMPORTANT!
Please perform the following steps in the order described
below. Failure to do so could potentially make the product unusable.
3
• M5x14 screws (2)
• M8 washers (2)
• Knobs (2)
• M5 lock washers (2)
• M6 lock washers (2)
• M6 washers (2)
• M8 lock washers (2)
• Knob pin (1)
• Allen wrench & Phillips screwdriver
• M6x35 screws (2)
• M8x20 screws (2)
Screws for Footplate
Screws for Armrest
Then use the two M8x20 screws, 1 M8 washer
and 1 M8 lockwasher to each screw. Fasten to
underneath overhang flange with handlebar
bracket pocket facing down.
5. Draw out the cord from the bottom of the Lower
Stand.
6. Connect the modular plug to the jack on one end of
the Base.
4.
Turn clockwise to lock the both Upper and Lower
Stand into position.
4
5
6
