8
Function Introduction
1. Copy
It copies data from source HDD to target HDD. You can set following settings
before copy. (You can check more detail in ”6. Setup”.)
I.
Set Copy Area of Source HDD → 6.1 Copy Area
II.
Set Copy Unknown Format Area → 6.4.1 Unknown Format
Start to copy
Step 1: Prepare Source & Targets
Prepare a source HDD and target HDDs.
(It’s strongly recommended the source and target are the same capacity.)
Caution
Various adapters are required to copy device with different
interfaces, e.g. IDE, eSATA, mSATA, and etc.
Step 2: Place Source & Targets
Place source HDD at source port, target HDDs to Target port.
Step 3: Enter Function "1.Copy"
Use
▲▼
to select "1.Copy", and then press "OK". Duplication will start to
proceed.
Note
If the user set “6.4.4 Wait HDD Time” at 3-30 seconds, the
machine will start duplicating automatically after HDDs initialize.
If the user set “wait key to start,” need to press “OK" to start.
