➅
Function Table
⌘
HQ200-H
Function
Item & Description (Example based on FW2.34.0)
1.Copy
Copy data from source to targets.
2.Compare
Compare bit-by-bit between source and targets to make sure accuracy.
3.Copy+Compare
Copy and Compare source to targets and immediately compare after finish
duplication.
4.Erase
4.1 Quick Erase
Erase the INDEX of HDD, and take very short time.
4.2 Full Erase
Erase the whole HDD, including empty space.
4.3 DoD Erase
Erase HDDs thrice, complying with US Department of Defense’s erase standard DoD
5220.22-M(E).
4.4 DoD EraseComp
Erase HDD thrice and compare once, complying with US Department of Defense’s
erase standard DoD 5220.22-M(E).
4.5 Secure Erase (*HQ200-H only)
Erase whole HDD, even HPA/DOC or other area which are not loadable, the
international authorized high standard Secure Erase.
5.Utility
5.1 Show Disk Info
Show the information of connected HDDs, such as brand name, total capacity, and
etc.
5.2 Show USB Info
Show the information of connected USB device, such as brand name, total capacity,
and etc.
5.3 Update System
Update the system firmware
5.4 System Info
Show the information of the duplicator, such as controller model number, software
version, and etc.
5.5 Read Speed
Show the speed of reading.
5.6 Write Speed
Show the speed of writing.
6.Setup
6.1 Copy Area
6.1.1 System and Files
Set to copy source HDD's data area only to save.
6.1.2 All Partitions
Set to copy source HDD's partition areas, skipping any non-partition,
empty areas.
6.1.3 Whole HDD
Set to copy the whole source HDD, including empty space.
6.1.4 Percentage(%)
Set up percentage range of HDD for copy. Enter Start and End
percentage.
25
