15
Fig. 9. Fixing holes marking
8.
Install and fix the enclosure cover with screw
9.
Connect the repeater in the U-Prox IP software
(according to the software manual)
10. Download the repeater
11. The repeater is ready for operation
Mount recommendations
Place the repeater in the place, convenient for service.
To mount the repeater on the wall (see Fig 9.) perform
actions:
Open the enclosure cover, remove the board and
mark fixing holes using the enclosure bottom as
template
Pull the power wiring through the opening in the
enclosure
Fix the enclosure bottom
Connect the power wiring
Communication
U-Prox HW uses wireless computer network and local computer network for
connection to U-Prox IC L. Device setup is possible with using autoconfiguration or
manually with a PC using the software "Configurator".
Appropriate configuration provides:
static or dynamic (DHCP) IP address assign to the repeater
operation with two (main and backup) IP or DNS (computer domain name)
U-Prox IC L addresses
operation in the Internet network with route backup possibility via the
second redundant router
U-Prox HW repeater operates in automatic mode. It routes event message data from
the allowed U-Prox IP500 wireless panels to U-Prox IC L panels connected to the
Ethernet computer network after the configuration data download.
The repeater communicator operates in the
notification
mode that means that data
transmission to U-Prox IC L panel is initiated on the access event.
Operating in the computer network U-Prox HW repeater provides encryption
protection of the data and commands with 256 bit key, unique serial number
supervision and communication channel supervision with periodical test messages.
Wireless computer network (Wi-Fi)
Repeater operates in wireless computer networks compliant to IEEE 802.11b/g/n
(frequency 2.4GHz, encryption WEP (Open), WPA, WPA2). Repeater supports
operation with two Wi-Fi access points (main and backup)
