Maintenance
U-Line Service
14
Maintenance
Lightbulb Replacement
To replace the lightbulb in your U-Line unit:
1. Find the light located at the top of the unit. Grasp the edges of
the light housing lens
(1)
opposite the exposed tab and gently
push the lens toward the tab
(2)
.
2. Pull the edge of the lens down
(1)
and swing it out of the light
housing.
1
2
NOTICE
ALWAYS use a genuine U-Line replacement 120V 10 watt
bulb (Part Number 31317) in the light housing. Use of any
other bulb within the housing will produce excessive heat,
causing damage to the light housing and cabinet interior, and
will compromise the precise temperature control of the unit.
1. Replace the lens by first inserting the tab side back into the
housing at a slight angle.
2. While gently pushing the lens towards the tab end, push the free
end into the housing, and release when you hear a snap.
Leveling
NOTICE
Unit must be level, for proper door and ice maker (if
equipped) operation.
1
For Models with adjustable leveling feet:
1. Use a level to check the levelness of the unit from front to back
and from side to side. Place the level along top edge and side edge
as shown
(1)
.
2. If the unit is not level, rotate the adjustable leveling legs to raise or
lower each corner of the unit
(5)
as necessary.
3. Check levelness after each adjustment and repeat the previous
steps until the unit is level.
Removing and Installing Grille
WARNING
!
Disconnect electric power to the unit before removing
the grille.
CAUTION
!
DO NOT touch the condenser fins (4). The condenser fins
are SHARP and can be easily damaged.
Removing the grille.
1. After disconnecting the power to the unit, remove the grille
mounting screws.
2. If there is a control knob
(1)
mounted in the grille it will pull
straight off.
3. Some grilles are equipped with a plastic filler
(2)
on the non-hinge
side.
2
1
Removing and Installing Interior Shelves
On the right side of the inner liner, there is a retention groove
molded into the side wall. Please slide the shelf from the unit.
NOTICE
Some wire shelves have a retaining clip that will need to be
removed to allow the shelf to slide forward.
