PAGE 4 OF 19
0721 IH-9330
MOUNTING CONTINUED
CONNECTING POWER WIRES
1. Connect white wire from outlet box to white wire from
fan using wire nut (not provided). (See Figure 9)
2. Connect black wire from outlet box to black wire
from fan using wire nut (not provided). (See Figure 9)
NOTE: Once wires are connected, carefully
tuck wires and wire nuts into outlet box,
ensuring wires are clear of downrod when
positioned in mounting bracket.
MOUNTING FAN/CANOPY ASSEMBLY
1. Place two housing screws and two lock washers (A)
on mounting plate that corresponds with slots in
canopy. Screw in with only two turns. (See Figure 10)
2. Position canopy to mounting plate, aligning slots to
two housing screws and two lock washers (B) and
turn to lock. Position and tighten all screws and
washers. (See Figure 10)
3. Carefully rotate fan assembly until groove in
hemisphere locks over tab of canopy assembly.
(See Figures 10-11)
WARNING! Failure to seat tab in groove could
cause damage to electrical wires and possible
shock or fire hazard.
NOTE: When installing fan on sloped ceiling,
ensure tab on hanger bracket faces toward
top of slope. Depending on slope, a longer
downrod may be required to prevent fan
blades from hitting ceiling.
MOUNTING BLADE BRACKETS TO BLADES
1. Place one carriage bolt through blade bracket,
blade, flat washer and lock washer. Attach with
hex nut using 5/16" wrench. Repeat for the three
remaining mounting locations. (See Figure 12)
MOUNTING BLADES TO MOTOR
WARNING! Turn off power before installing.
1. Insert blade arm into fan. Tighten using Phillips head
screwdriver, three Phillips head screws and three
lock washers. (See Figure 13)
2. Slightly turn blade after installation and repeat for
the remaining blades.
Black Wires
White Wires
Figure 9
Hemisphere
Downrod
Groove
Figure 11
(A)
(B)
Figure 10
Canopy
Hex Nut
Lock Washer
Flat Washer
Blade
Blade Bracket
Carriage Bolt
Figure 12
Figure 13
Lock Washer
Motor Screw
