PAGE 4 OF 12
1120 IH-7808
7. Set the unit upright and tighten all nuts and bolts
around the entire unit.
8. Insert the shelves (4)
at desired levels.
(See Figure 7)
NOTE: To place
the shelves, tilt
the shelf slightly
to the left or right
before inserting
into the unit.
9. Attach the left door (8) to the unit by placing the door
on the hinges,aligning the hinge holes, dropping the
hinge pins into the slots, then placing the flat end of
a screwdriver on the hinge pins and tapping them in
with a hammer. (See Figure 8)
10. Attach the right door (9) to the unit the same way the
left door was attached. (See Figure 9)
NOTE: If having issues
with doors aligning, it
may be due to cabinet
not sitting level. Use
included nut driver to
adjust leveling feet
in bottom front two
corners. Nut driver
should insert through
inside of cabinet down
into feet and adjust as
needed.
HANDLE/LOCKING SYSTEM INSTALLATION
1. Place the locking handle (11)
on the righthand door and
fasten with two #8-32 x 1/4"
slotted hex head bolts and
lockwashers. (See Figure 10)
2. Turn the handle to the
open position. Place
the locking cam (12)
over the square shank
of the door handle.
The latch must be
facing downward as
shown. (See Figure 11)
Place the cotter pin (13)
through the hole of square shank. (See Figure 12)
3. With the handle still in the open position, hook the
locking bars (10) to the locking cam. (See Figure 13)
Once in position, slowly rotate the door handle to
the closed position so the lock bars protrude from
the holes at the top and bottom of the door.
4. Slide the nylon lock bar guide inserts (14) over the
lock bar ends and through the door slots. Push firmly
until the guides snap into place. If necessary, turn
the handle back to the open position and gently
tap with a hammer until the guides slide into place.
(See Figure 14)
ASSEMBLY CONTINUED
10
12
Figure 13
14
14
Figure 14
11
Figure 10
13
12
Figure 11
Figure 12
15
8
Figure 8
4
Figure 7
9
Figure 9
1-800-295-5510
uline.com
