PAGE 4 OF 31
0821 IH-5839
PARTS
ASSEMBLY
M8 Flange
Nut x 2
M6 x 10 mm
Screw x 9
Cap Nut
x 9
Wing Nut
x 3
Stainless
Steel Bolt
x 4
(May be attached
to head assembly)
Wrench
x 1
Reinforced
Ring x 1
Deck Ring x 1
M8 x 16 mm
Bolt x 2
M5 x 8 mm
Screw x 4
M6 x 10 mm
Bolt x 4
Small Flat
Washer
x 4
Medium Flat
Washer x 9
Large Washer
x 9
Reflector
Spacer
x 3
1. Line up holes on the
bracket of wheel
assembly with the
corresponding
holes on base,
then insert 16 mm
bolts through holes.
Hand tighten with
flange nuts. Be sure
the wheel assembly
is parallel to the
base. (See Figure 1)
NOTE: To improve stability, the bucket (in base)
can be filled with sand (not included).
2. Attach cylinder
housing loosely
to base with
M5 x 8 mm screws.
(See Figure 2)
3. Open the
preassembled door
on cylinder housing
and place post
through the hole on
the top.
(See Figure 3)
(See Figure 3)
4. Secure post to
cylinder housing
using the reinforced
ring, M6 x 10 mm
bolts and four small
flat washers. Fasten
and cover with the
deck ring.
(See Figure 4)
Fill sand
Figure 1
Figure 3
Figure 4
TOOL REQUIRED
Phillips Screwdriver
(not included)
Figure 2
