PAGE 4 OF 12
0421 IH-5552
5. Insert rear legs (9) into the corner between the bottom
and the side. Bolt the leg to the side and back using
six bolts and nuts per leg. (See Figure 4)
6. Place door and door frame assemblies (5 and 6) over
the locker body. Make sure body sides are inside the
frames. Attach top to frame header and the bottom
to frame sill. Finish by attaching side panels to door
frame. (See Figure 5)
7. Attach box door latch pull (7) to each door using two
bolts (10) and two high-dome cap nuts (11) per door.
(See Figure 6)
8. Attach number plates (8) using push pins
(See Figure 6)
9. Stand unit upright and place in desired location.
Check and tighten all bolts.
SECURING UNITS
Anchor units to wall or floor. Unanchored units may fall
over if not secured. (Units standing back to back should
be bolted together.)
CAUTION: Care must be taken to assure that
lockers are set plumb and true before anchoring.
9
Figure 4
ASSEMBLY CONTINUED
Header Bolt Hole
6
5
Figure 5
Hinge
11
7
10
8
Push
Pins
Figure 6
1-800-295-5510
uline.com
