PAGE 5 OF 18
0421 IH-4017
PLUGGING DATA CONNECTOR INTO DISPLAY
(CONTINUED)
3. Mark which push button is plugged into the (+) and
(–) jacks:
(+) Push button advances the numbers.
(–) Push button goes back to previous numbers.
CONNECTING AC POWER SUPPLY
WARNING! Do not connect display to power
until all push button and power connections
are complete. Serious electrical shock, injury
or death may result.
1. Plug the AC power supply into either of the two
power receptacles located on the back of the
display. (See Figure 12)
2. Choose the appropriate country outlet adapter and
slide it into the AC power supply. (See Figure 13)
3. Attach 10ft. power extension cable if necessary.
(See Figure 14)
4. Plug the AC power supply into the nearest outlet.
SETUP
SETTING SOUND TONE AND VOLUME
Use a mini flathead screwdriver to change the tone and
volume switches on back of the display. (See Figure 15)
Set the sound tone with switches 1-2:
• No sound: 1-OFF, 2-OFF
• Single tone: 1-OFF, 2-ON
• Double tone: 1-ON, 2-OFF
• Triple tone: 1-ON, 2-ON
Set the volume with switches 3-4:
• Low volume: 3-OFF, 4-OFF
• Medium volume: 3-ON, 4-OFF
(recommended in most cases)
• High volume: 3-OFF, 4-ON
• Highest volume: 3-ON, 4-ON
DISPLAY START-UP
The display shows a number of messages on start-up
once it is plugged in.
Display shows:
• Program version: "P-", then number
• TOM-Net address: "Ad", then 51 or 21
• Last number displayed when power was
disconnected: Number, ("00" if first-time start-up.)
• Error message if display is set as a duplicate master:
"Ed"
DISPLAY – MOUNTING AND INSTALLATION CONTINUED
Figure 15
Figure 14
Power Connector
Power Extension Cable
Figure 12
Power Cable
Figure 13
AC Power
Supply
Adapter
Country Outlet
Adapters
