PAGE 3 OF 15
0221 IH-3594
ASSEMBLY
ASSEMBLING CABINET
1. Place the two back panels (1) on a protected
surface. The bottom flange should be facing
upward. Bolt panels together using 7 bolts and nuts.
(Nuts on the inside of the unit.) (See Figure 1)
NOTE: When bolting the unit together, leave the
bolts slightly loose until step 7, unless otherwise
specified.
2. Attach the left side (3) to the back by placing flange
around the back and bolting the back and sides
together. Be sure that the shelf supports on all shelf
adjustment strips point up on both back and side.
(See Figure 2)
3. Attach the top (4) to the unit by sliding the outer
flange over the back of the unit and the side flange
on the top over the side panel. The threaded studs
should go through the holes in the top flange of the
side and fasten with 3 nuts. Attach the back to the
top using 4 bolts and nuts. (See Figure 3)
4. Attach right side (2) in the same manner used in
Step 2. Make sure the side flange overlaps the back
panel and the flange on the top is over the right
side. Push the side panel up so the studs in the top
go through the holes in the top flange of the side.
Fasten with 3 nuts. (See Figure 4)
TOP
BOTTOM
1
Figure 1
3
1
Figure 2
3
2
1
Flanges
on top
go
over the
back
& sides
3
1
4
Threaded studs
go through the
holes in the
flange at the
top of the side.
Figure 3
Figure 4
