PAGE 3 OF 12
0521 IH-2932
1. Use indent to pull battery away from the unit.
(See Figure 1)
2. Make sure it is fully extended out. (See Figure 2)
3. Swing battery cover up. (See Figure 3)
4. Using Allen wrench, remove retaining screw.
(See Figure 4)
5. Pull out battery holder. (See Figure 5)
6. Replace battery. (See Figure 6)
When entering a valid code, you should hear a click
sound. The green LED will light up, and you can turn the
knob to the unlocked position.
An incorrect code is indicated by 3 flashes of the red LED.
Five incorrect entries will result in the lock being
temporarily disabled for 2 minutes. During this time, any
entry attempts will be met with 3 flashes of the red LED.
TO RE-LOCK:
Turn the knob from the unlocked position to the locked
position. Listen for the lock mechanism to operate (there
will be a click sound). Confirm the knob is locked.
USING LOCK IN LOCKER MODE:
Follow the procedure below to change operation mode
from single user/station mode to locker mode :
1. Unlock the unit.
2. Remove the battery for 10 seconds.
3. Press the program key while the battery is removed.
4. Insert battery and continue holding program key.
5. Wait until all three LEDs turn on and off.
6. Release the program key.
7. Enter the 6-digit master code.
8. If code was entered correctly, the yellow LED will
light up.
9. Press number 2 button.
10. Once the lock switches to locker mode, the LEDs will
each flash for 1 second in the following order: green,
yellow, red.
11. Proceed to operate the lock in locker mode.
OPERATION
REPLACING THE BATTERY
Indent
Figure 1
Figure 4
Figure 5
3-Volt Lithium CR2032
3-Volt
Figure 6
Figure 2
Figure 3
