PAGE 14 OF 18
0721 IH-1820VND
H-1820
14
P3 ALL AROUND - PRESTO PALLET POSITIONER
Safe Servicing of the Lift
The two holes in the base roller tracks, one on
each side (see Choked Position image) are
intended for 3/8 inch diameter pins to be utilized
to chock up the lift whenever maintenance or
under lift troubleshooting is performed. When
chocks not in use place in the Stowed Position,
see image on the right.
Note: Earlier designs may not have had these
pins or the stowed position holes. If your unit
was not supplied with these, use two 3/8 x 3''
long bolts.
Figure 8. Safe servicing of the Lift
2 When equipped with the optional Portability Set
release the floor lock and move the unit. Be sure
to engage the floor lock once the P3 All Around is
re-located.
3. When equipped with the optional leveling feet
the base frame can be raised approximately 3''
from the floor allowing access for a hand (or pow-
ered) pallet jack to be positioned under the center
of the base frame.
Note that certain Presto supplied and approved
portability kits installed on the P3 All Around allow
the unit to be rolled around on smooth level sur-
faces when loaded.
Stowed Position
Chocked
Position
One pin
on each side
