0513 IH-1027
PAGE 9 OF 11
pUsHer sprIng replaceMent
1. Loosen the screws and nut with a 8 mm spanner
wrench and a 4 mm Allen wrench. (See Figure 21)
2. Remove the magazine assembly. (See Figure 22)
3. Pull the pusher back until it stops on the rod, then
rotate the pusher to position. (See Figure 23)
4. Push the magazine seat back and remove it from
the magazine.
Magazine
Assembly
Spring
Pin
Pusher
Pusher
Guide
operatIng InstrUctIons contInUed
5. Loosen the screw and nut with a 2.5 mm Allen
wrench and 7 mm socket wrench. (See Figure 24)
6. Loosen the rod with a 6 mm offset wrench and
remove the pusher guides. Remove the pusher.
(See Figure 25)
7. Remove the spring pin with a hammer and 4 mm
straight rod. (See Figure 26)
Figure 21
Figure 24
Figure 22
Figure 25
Figure 23
Figure 26
