PAGE 2 OF 18
0323 IH-1024
OPERATION
LOADING THE STAPLER
1. Pull the pusher back until it stops on pusher pivots.
Rotate pusher to position. (See Figure 1)
2. Insert up to two sticks of appropriate staples into the
magazine. Let the sticks slide forward to the front of
the magazine. (See Figure 2)
3. Pull the pusher back to an upright position and
gently let the pusher slide forward against the
staples. Do not let the pusher slide forward and
strike the staples at high speed as this may deform
the staples and damage the stapler.
ADJUSTING STAPLE LEG LENGTH
1. Loosen set screw with a 3 mm Allen wrench
on bottom of stapler. (See Figure 3)
2. Turn adjusting rod 180º with a screw driver
to desired setting.
(See Figure 4)
NOTE: If using 3/4" staples, set
"
L
"
up.
NOTE: If using 5/8" staples, set
"
S
"
up.
3. Tighten set screw.
Figure 1
Figure 2
Figure 3
Figure 4
