QUICK START GUIDE
u-line.com
Integrated Panel Installation
Integrated Models Only
1. Fully open door.
2. Starting at corner, pull gasket
away from door.
3. Continue to pull gasket free from
gasket channel.
4. Upon removal, lay gasket down on
a flat surface.
5. Align top of panel with top edge of
door. Center panel on door.
NOTICE
Due to differences in floor construction or
surrounding cabinetry, the panel may not sit
flush with the top of the door.
6. Secure integrated
panel to door using
clamps. A robust
tape may also
be used. U-Line
recommends the
use of bar clamps
to secure the panel
to the door. If using
tape, be certain the
tape will not damage
panel finish upon
removal.
7. Using a 7/64” (3
mm) drill bit, drill 6
pilot holes into the
wood panel 1/2” (12
mm) deep using the
holes in the door
frame as a guide.
NOTICE
It is important to ensure that all drilled holes are
drilled to the correct depth in order to avoid
splits in the wood when hardwood is installed.
8. Locate 6 of the #6x 1-1/2” (38 mm) screws provided
with your unit.
9. Using a Phillips screwdriver, place one screw into
each of the 6 pilot holes and screw down. Do not
overtighten screws.
10.
Ensure the screws sit flush against the bottom of the
channel.
11. Remove clamps from door.
If panel requires additional adjustments after
removing clamps, slightly loosen each screw and
adjust panel as necessary. Tighten screws upon
completion.
12. Starting at the corners, re-install the gasket into the
gasket channel in the frame. Make sure the gasket is
fully seated.
Wood
Panel
Door/Drawer
Bar
Clamp
Bar
Clamp
Integrated Panel
Integrated Panel
9
