µ-Dimension SST 1200es, User Manual

Page: 55 / 74

Dimension BST 1200es / SST 1200es User Guide
Maintenance 55
NOTE
Because the material ‘unloaded’ during the tip
replacement, the printer is in a material replacement
mode. You must unlatch/latch the cartridges to continue.
If there is a delay in the unlatch/latch process, the
printer will display
Both Cartridges Not
Replaced Or Invalid . Select Retry , then unlatch/
latch the cartridges.
B. The printer will now begin to load material. See “Loading
Material” on page 32 , paragraphs 9 and 10 on page 35 for
procedure
C. After Material Loading is complete the printer will display
Tip Calibration - Install Modeling Base And
Build Calibration Part
.
Tip Calibration
Tip Replacement requires that a Tip Calibration must be
performed.
1. Select
Start Part
(flashing) - the printer will run two
calibration parts.
•
The printer will automatically build a Z Calibration part,
measure the part and calibrate the Z Axis for tip depth and
tip level (approximately 5 minutes).
• The printer will then automatically build an XY Calibration
part (approximately 10 minutes). You must inspect the XY
Calibration part and calibrate the X and Y axes for tip
offset:
2. When the XY Calibration part is complete the printer will
display
Remove Part and Select XY Adjustment -
X:0, Y:0
CAUTION
Make sure a NEW, UNUSED modeling
base is installed before starting
calibration. Calibration results will be
incorrect if a NEW, UNUSED modeling
base is not used.