µ-Dimension SST 1200es, User Manual

Page: 35 / 74

Dimension BST 1200es / SST 1200es User Guide
Operation 35
10. Next you are prompted with
Support Load - Ready to
Load
(if not previously loaded)
.
Press
Load
to load support
material.
•
Watch the support extrusion tip (see Figure 12 ) to see if
material extrudes (purges) after loading. The panel will
then display
Did Support Material Purge?
• Press
Yes
(to return the printer to the
Ready to Build
state) or
No
(to return to
Load Materia
l) as appropriate
— or press
Purge Again
if you’re unsure which to
choose.
Figure 12: Close-up of extrusion tips
NOTE
If the display shows Load Failed , press Retry . If load fails
again, remove the cartridge, snip the material (see
Figure 11
on
page 34 ), remove filament in the printer, and reinsert the
cartridge.