µ-Dimension SST 1200es, User Manual

Page: 34 / 74

34 Operation
Dimension BST 1200es / SST 1200es User Guide
Figure 11: Snipping the material filament
6. If the printer is in
Idle
, press the
Load Material
button,
which will be blinking.
7. Display will prompt with
Load Model - Replace Both
Cartridges
(flashing).
8. Insert material cartridges into their appropriate slot from the
front of the printer (Model material cartridge goes in the Top
slot; Support material goes in the Bottom slot).
NOTE
You might get the message,
Cartridge Not Replaced Or
Invalid
. This occurs if you do not insert the new cartridges
within 30 seconds. In this case the cartridge will not lock into its
slot. You must press the
Retry
button before continuing the
process.
9. The panel will display
Material Load - Ready To Load.
Press
Load
to load model material. (Or, if the model material
has been previously loaded, the panel will display
Load
Support - Replacing Support.
Skip to Step 10 .) Display
with show percentage of material left in cartridge.
•
Watch the model extrusion tip (see Figure 12 on page 35 )
to see if material extrudes (purges) after loading. The
panel will then display
Did Model Material Purge?
• Press
Yes
(to continue) or
No
(to return to Load Material)
as appropriate — or press
Purge Again
if you’re unsure
which to choose.