EVK-JODY-W3 - User guide
UBX-20030840 - R04
Board description
Page 25 of 29
Jumper J411 can be removed to turn the LEDs off for module power measurements.
Figure 21: LED enable jumper
3.12
Reset buttons
Two buttons, SW500 and SW501, can be used to reset the JODY-W3 module and the whole EVB,
respectively.
Button SW500 asserts the
PD#
pin of the JODY-W3 module to enter power down mode, while keeping
the supply rails enabled. When exiting the power-down mode, the module is automatically reset and
the firmware must be downloaded again.
Button SW501 causes all the module supply rails from the on-board Power Management Unit (PMU)
to shut down. Internal power-on reset of the module is triggered when the button is released, which
restores power to the module.
3.13
Schematics
Complete schematics for the JODY-W3 evaluation board (carrier and module board) are available on
request. For further information,
your local u-blox support team.
J411
