USER MANUAL
ARMING THE VSS
Press the button on the remote - direction indicators blink and single siren chirp (*) confirms the vehicle
security system is arming and the central door locking is locked. The LED will light constantly and after
10 seconds it will start to blink slowly.
ARMING WITH INTERIOR MOTION DETECTOR AND ADDITIONAL SENSOR DISABLED
If the VSS is armed with any person or animal in the vehicle, their movement will trigger the alarm.
To avoid such situation, the system can be armed without interior motion detector and additional sensors.
To do so, before arming the system - press and hold the PA button until the LED starts to blink rapidly. Exit the
vehicle, close all doors and press the button of the remote - two siren chirps confirm arming without
interior motion detector and additional sensor. Direction indicators blink confirms the vehicle security system
arming and the central door locking is closed. The LED will light constantly and after 10 seconds it will start
to blink slowly.
DISARMING AND OPENING THE CENTRAL DOOR LOCKING SYSTEM
Press the button of the remote - blink of the direction indicators and double siren chirp (*) confirms
disarming of VSS and unlocking central door locking system. The status LED will start blinking until any door
is opened and then will go off.
If the alarm was triggered during the driver’s absence, the VSS signalises it with three siren chirps.
IMPORTANT!
If after disarming neither doors nor trunk is opened within 30 seconds the system rearms automatically.
tytan ds410 can
5
TRUNK RELEASE BUTTON LOGIC
In case of remote control with trunk release button its press will open the boot and turn off the
protection on trunk switch, interior motion detector and additional sensors. That state is confirmed by fast
blinking of the LED. Closing the boot brings the security system again into the set state.
IMPORTANT!
This feature is car dependent.
