TYROLIT
Hydrostress AG
Page 14
Ring saw HRE400
Power supply
INFORMATION
• The power supply must correspond with the information on the type plate.
• Protect the connecting cables from heat, oil and sharp edges.
• Do not use connecting cables for purposes for which they are not intended.
• Never carry the electrical tool using the connecting cable.
• Do not use the connecting cable to pull the plug out of the socket.
• In the event of power failure: switch off the electrical tool, pull out the plug.
Extension cable
• Use only approved and appropriately marked extension cables outdoors.
• Do not use extension cables with multiple sockets and operate several devices simultaneously.
Always use an extension cable with a sufficient cross-section that is approved for the field of
application.
Do not use an extension cable with a conductor cross section of 1.25mm² and 16 AWG.
Recommended minimum cross-sections and maximum cable lengths
Cross section mm²
1.5
2.0
2.5
3.5
4.0
110 V
Not permit-
ted
Not permit-
ted
Not permit-
ted
20 m
20 m
220-240 V
20 m
-
40 m
50 m
60 m
Risk of property damage
Cutting with the side of the disk grinding ring
Cutting with the sides of the ring can damage the disk grinding ring.
X
Do not cut using the sides of the disk grinding ring.
Defective water cooling
The disk grinding ring can be damaged if the water cooling is faulty.
X
Do not operate the electrical tool without water cooling.
Frost damage
X
When work is completed or before longer work breaks drain and blow out the water system.
Storage
X
Store the electrical tool securely in a dry room. Do not store the electrical tool outdoors.
Ensure children are unable to gain access to the electrical tool.
2.10.2
2.11
2.11.1
2.11.2
2.11.3
2.11.4