7
TyrePal Limited, Unit 2 Glen Industrial Estate, Essendine, Stamford, PE9 4LE. United Kingdom
Tel: +44 (0)1780 755490 e-mail: [email protected] www.tyrepal.co.uk
© TyrePal Ltd 2013
TC215E 20130319
7.
If you need to delete a setting, use the
+
or
–
buttons to select the tyre then
press and hold the
SET
button for three seconds. A double beep confirms the ID
has been deleted.
8.
When all sensors are registered, press and hold the
CODE
button to exit.
Note: If a sensor is coded twice to the same monitor, the previous setting will be deleted
automatically.
4.2 Alternative registration by proximity (Low Frequency)
This procedure can be used to register the sensors without installing them on the vehicle.
1.
In standby mode, press and hold the
CODE
button for 3 seconds. Release it after
the beep to enter coding mode.
2.
Press the
+
or
–
button to select the desired tyre position.
3.
Press the
CODE
button again to enter Low Frequency mode. The display shows a
flashing tyre icon and
LF
together with the letters
Id
.
4.
Place the sensor close to the monitor and press the
CODE
button once more. The
LF
icon flashes and the red light shows on the monitor.
5.
On receiving the code, the monitor gives a long beep and the tyre position is
stored together with the sensor ID. The tyre icon continues to flash after the code
is received.
6.
If the monitor does not receive the code within 6 seconds, an error message
ERR
is displayed, a double beep is given and the red light goes out. Move the sensor
closer to the monitor and repeat steps 4 and 5.
7.
Press
+
or
–
buttons to select the other tyres and repeat for all the tyres that are
to be monitored.
8.
When all sensors are registered, press and hold the
CODE
button to exit.
4.3 Alternative registration by direct input of code
1.
In standby mode, press and hold the
CODE
button for 6 seconds and release it
after the second beep (Do not release it after the first beep).
2.
Press the
+
or
–
button to select the desired tyre position.
3.
Press the
CODE
button to scroll through each digit code and then use the
+
or
-
buttons to change the value of each digit.
4.
Press the
SET
button to save the ID code
5.
When all sensors are registered, press and hold the
CODE
button to exit.