TyrePal Limited, Unit 2 Glen Industrial Estate, Essendine, Stamford, PE9 4LE. United Kingdom
Tel: +44 (0)1780 755490 e-mail: [email protected] www.tyrepal.co.uk
© TyrePal Ltd 2013
TC215E 20130319
6
4. INSTALLATION
4.1 Install and register the sensors
Sensors are interchangeable and can be registered to any of the 22 possible wheel
positions. Once sensors are registered, the display only shows data from the registered
positions.
The following procedure registers the sensors as they are installed. If preferred, they can
be registered without installing them on the vehicle; see the alternative registration
procedure described on the next page.
1.
Label each sensor to identify its position. The numbers can be recorded here:
2.
In standby mode, press and hold the
CODE
button for 3 seconds. Release it after
the beep to enter coding mode. A flashing tyre icon is displayed. If no sensor is
registered to this position, the letters FFF FFF are shown. If a sensor is already
registered, the sensor ID is shown.
3.
Press the
+
or
–
button to select the desired tyre position.
4.
Screw the sensor onto the tyre valve using the security tool as shown. The system
allows different types of sensor to be specified. If appropriate, instructions for
alternative sensors are detailed in supplementary sheets.
5.
As it senses the air pressure, the sensor sends its ID code to the monitor. The
monitor beeps and stores the tyre position with that sensor ID. If it does not
register within a few seconds, unscrew the sensor and try again.
6.
Press
+
or
–
buttons to select the other tyres and repeat for all the tyres that are
to be monitored.