typical GT1790A, Instruction Book

Page: 44 / 85

- 41 -
No. Item Setting range Edit unit Remarks
S021
Reinforcement of radial shape
This item sets sewing pitch of bar-tacking section.
0.200 ~ 2.500 0.025 mm -
S022
1
st
clearance
This item sets the clearance between 1
st
bar-tacking and
knife groove.
This item is applied to all shapes.
0.0 ~ 4.0 0.1 mm -
S023
2
nd
clearance
This item sets the clearance between 2
nd
bar-tacking and
knife groove.
This item is applied to all shapes.
0.0 ~ 4.0 0.1 mm -
S031
Single/double stitching
This item selects single or double stitching.
- - -
S032
Double stitching cross selection
This item selects overlapping stitching or cross stitching at the needle
entry of parallel section when setting double stitching.
- - *3
S033
Correction of double stitching width
This item sets amount to narrow overedging width of 1 st
cycle when setting double stitching.
0.0 ~ 2.0 0.1mm *3
S034
Number of basting times
This item sets number of basting times.
0 ~ 9 1 -
S035
Basting pitch
This item sets pitch at the time of basting.
1.0 ~ 5.0 0.1mm *3
S036
Rolling length of basting
This item sets rolling length of needle thread when
performing basting.
2.0 ~ 20.0 0.1mm *3
S037
Rolling pitch of basting
This item sets rolling pitch of needle thread when
performing basting.
0.2 ~ 5.0 0.1 mm *3
S038
Rolling width of basting
This item sets rolling width of needle thread when
performing basting.
0.0 ~ 4.0 0.1mm *3
S039
Lengthwise compensation of needle entry of basting
This item sets the amount to move needle entry position
back and forth when performing basting more than two
cycles.
0.0 ~ 2.5 0.1 mm *2, *3
*1: Displayed according to the shape.
*2: Displayed when it is set to with edit. Refer to
“V-12. Method of setting sewing data with/without edit” p.32 .
*3: Displayed when the function is selected.
Single
stitching
Double
stitching
Top of square
type
Top of round
type
Top of semilunar
type
Bottom of
square type
Bottom of
round type
Bottom of
semilunar
type
Bottom of
straight
bar-tacking
Bottom of
taper
bar-tacking
Double
stitching
Cross
stitching
Without
basting
With basting
(setting times)