30
2
2
1
1
1
2
TYPICAL GC6760 Series
8 // CLEANING AND MAINTENANCE
8/1/3 Refi ll oil
Use only oil which is recommended by TYPICAL.
1. Remove rubber plug (2)
2. Refi ll oil until oil level is approx. 1 mm above the center
mark on the oil sight window. Replace only 10 mm at one
time. Than check again. If it is still too low repeat. Never
fi ll in too much oil at one time otherwise it can spill out.
3. Replace rubber plug (2) to the opening.
4. Bring sewing head back in the upright position.
The rubber plug has a small opening to regulate the
air pressure. In case it has to be replaced make sure
that you use one which is recommended by TYPICAL.
8/1/4 Checking the oil level
1. Check the oil level on the oil sight window (1)
2. Refi ll oil when the oil level is below the lower mark (2) on
the oil sight window.
Upper
gauge level
Lower
gauge level
ca. 1 mm
Summary of Contents for GC6760 SERIES
Page 2: ...2 TYPICAL GC6760 Series...
