9
JUMP STARTING CONT.:
3. Connect the
RED
clamp to the POSITIVE
(+) post on the car battery. The POSITIVE
battery post will be slightly larger than the
NEGATIVE post, and will be marked with a
PLUS (+) sign. There may also be a
RED
plastic protective cover over the positive
battery post.
4. Connect the
BLACK
clamp to the NEGATIVE (-) post on the car battery.
The NEGATIVE will be marked with a MINUS (-) sign. There may be a
BLACK
plastic protective cover over the negative battery post.
NOTE:
Do not connect the
RED
clamp (+) and the
BLACK
clamp (-) at
the same time. Connect the
RED
clamp first, then the
BLACK
clamp.
CAUTION:
DO NOT lean directly over the battery while making jumper
connections.
5. Check the LED status on the Polarity Circuit Protection Box. Proceed to
the next step unless the LED is flashing
RED
and BEEPING. Reference
Polarity Protection Circuit Status chart in the next section.
6. Once the clamps are properly connected to the vehicle battery, the LCD
Display will read:
Ready, Start vehicle
ignition.
You have 90 seconds to start
your vehicle before the PROJUMP
shuts off in order to prevent the vehicle
battery from reverse charging the unit.
NOTE:
If vehicle does not crank, or cranks very slowly, wiggle the
cable clamps on the vehicle battery to ensure they are making good
contact. Wait 60 seconds before trying to jump start your vehicle again.
Each new jump start attempt requires disconnection of both
clamps from the vehicle battery and reconnection.
80%
Ready, Start vehicle
ignition.
80%
Successful Jump,
unplug cables.
80%
Clamp cables to
battery.
80%
