TYM T303HST, Workshop Manual

Page: 115 / 249

6) MID PTO STOPPER OPERATION
①
When PTO switch is ON at engine works,The hydraulic fluid of PTO Valve flows to PTO
clutch through hydraulic pipe,and let PTO shaft rotate which is engaged to Gear(16/23).
②
The fluid flows to actuator and piston operates to protrude.
③
If MID PTO lever is ON before MID PTO switch is ON position,It is normal operation and if
MID PTO is to be stopped,MID PTO switch must be OFF position.
④
The PTO switch must be OFF before PTO is engaged.
(Normal process : Engage MID PTO lever to ON -> MID PTO switch ON )
- The speed of MID PTO is 2,000 rpm.Use the mid PTO lever to engage.
- Decrease engine speed to near idle.
- Make sure that PTO switch is OFF
- If operator turns off PTO switch,Rear PTO and Mid PTO are off at once.
5-14
Fig.5-22
CAUTION
Do not operate any implement at a high speed than is specified for it. When making
adjustments to the implement, stop the engine to avoid serious injury. When remove
the Key. Set the parking brake