TYLZA TYWC100, Instruction Manual

Page: 7 / 16

7
Illustration #1 Illustration #2
To Install Your Wine Cooler
 This wine cooler is designed for free standing or built-in (fully recessed) installation.

Place your wine cooler on a solid and level floor that is strong enough to support it when it is
fully loaded. This will ensure a vibration-free and noise-free operation. Adjust the leveling
legs in and out to stabilize the cooler horizontally. If the legs are not properly adjusted, the
cooler may be unstable and result in excess noise or vibration.

Locate the wine cooler away from direct sunlight and sources of heat (stove, heater, radiator,
etc.). Direct sunlight may affect the acrylic coating and heat sources may increase electrical
consumption. Extremely cold ambient temperatures may also cause the cooler not to perform
properly.

It is not advisable to install this cooler in moist areas or directly adjacent to a kitchen sink, as
moisture could cause premature corrosion to the components of your new cooler.

It is recommended you install the wine cooler in a place with temperatures
above 60°F (15°C)
and below 90°F (32°C) , and humidity is under 60%. If the ambient temperature is above or
below recommended temperatures, the performance of the cooler may be affected. Placing
your cooler in extremely cold or hot conditions may cause interior temperatures to fluctuate,
and the temperature range of 5ºC-22ºC (41ºF-72ºF) may not be reached.
1 Gasket
2 Screw
3 Screw Driver
4 Handle