10
Unusual voltages/numbers of phases
Contact Tylö Customer Service before connecting to voltages
or numbers of phases that are not listed in the wiring diagram
Figure 11, page 11.
Figure 9: Installing the sensor
Figure 10: Seal any holes
5.
Connect the sensor cable (6) to the NTC contact on the
circuit board (position 1) (5) (see the Connection/wiring
diagram section) according to the wiring diagram (see the
Connection/wiring diagram section, page 11).
6.
Connect the light cable (if relevant) (7), see Figure 8 page 9,
to the terminal (8) according to the wiring diagram Figure 11,
page 11.
7.
Close the cover and tighten the screws (see Figure 7, page 9).
8.
Install the sensor on the wall, see Figure 9. The thermistor
wire may also be passed through the wall. Seal any holes
in the wall behind the sensor, see Figure 10. The thermistor
wire may be extended outside the sauna using low voltage
wire (2-lead).
